How to Organize Cables and Gear with Elinchrom Cable Ties
By The Flash Centre | Published: 2026-10-31
Category: How-to Guides
Learn a practical, step-by-step method to tame studio cable clutter using Elinchrom Cable Tie / Wrap. Keep light cables tidy, visible, and ready for the next shoot.
Quick answer
Use Elinchrom Cable Tie / Wrap to bundle each light cable individually, attach the tie permanently with its elasticated loop, and store cables in labeled coils so you can grab the right one without untangling. The red tag makes each bundle easy to spot in a crowded case or on set.
Why individual cable ties beat one big bundle
Wrapping all cables into a single coil saves space but creates a mess when you need just one. Tying each cable separately with its own tie keeps them distinct, reduces knots, and lets you pull out a single cable without disturbing the rest. This is especially useful for light cables that run across the studio floor and need to be traced quickly.
The elasticated loop on the Elinchrom tie stays attached to the cable, so you never lose the tie between uses. That small detail matters in a busy studio where loose ties tend to disappear.
When a simple tie is not enough
Cable ties organize, but they do not protect cables from foot traffic or sharp edges. For permanent runs along walls or under desks, combine ties with gaffer tape or cable ramps. Also, avoid over-tightening: the tie should hold the coil shape without crushing the cable jacket. If a cable feels warm after use, give it more slack before tying.
Step-by-step: tidy your studio cables with Elinchrom ties
- Unplug and inspect each cable: Before tying, unplug every light cable and run your hand along its length to check for cuts, exposed wire, or bent pins. Coil each cable loosely in your hand, following its natural curve, and secure the coil with a temporary twist tie or hook-and-loop strap. Never tie a cable while it is still plugged in; always disconnect power first.
- Attach one tie per cable: Slide the elasticated loop of an Elinchrom Cable Tie / Wrap over one end of the cable and pull it snug so the tie stays attached. Then wrap the tie around the coiled cable and fasten it. The red tag should face outward for visibility. Check that the tie holds the coil but does not compress the cable jacket; you should be able to slide a finger under the tie.
- Label both ends of the cable: Use a piece of tape or a label maker to mark each cable's length and intended use (e.g., '5m light cable – key light'). Place the label near the connector, not on the tie itself, so it stays readable. Label before you tie if possible; it is harder to write on a coiled cable.
- Store cables in a case or bin by type: Arrange coiled cables in a dedicated case or bin, standing them upright or laying them flat so you can see the red tags. Group similar cables together (e.g., all light cables, all sync cables) to speed up setup. Do not overfill the case; leave room to pull out a single cable without disturbing others.
- Do a quick check before each shoot: Before packing for a shoot, verify that each cable is tied, labeled, and free of damage. Replace any tie that has lost its elasticity or any cable with worn insulation. A two-minute check prevents mid-shoot failures and keeps your cable management system working.
Product facts
- Elinchrom Cable Tie / Wrap: Elasticated loop lets you fix the tie to the cable, and a red tag keeps it highly visible. You can leave the tie on the cable between shoots, so it is always ready and easy to find in a dark case or on a cluttered set.
Elinchrom Cable Tie / Wrap
